Domes
A Dome has a curved profile. The curve may be shallow, like a tank head,
or deep, like a hemisphere. The curve can also be elliptical, like a
nose cone for an airplane.
Tank Head
Both of these Tank Heads are used in the cryogenic industry.
These stainless steel parts must be free from scratches and consistent
in diameter.
 |
|
|
| |
| |
|
| |
|
|
| Diameter |
16.00" |
3.40" |
| Height |
04.60" |
1.03" |
| Material |
Stainless |
Stainless |
| Thickness |
0.060" |
0.018" |
| Finish |
Mill |
Mill |
|
|
|
| |
Shroud
This aluminum hemisphere is used in the electronic industry.
Precise positioning for four mounting holes and two half moons
are critical. The high gloss powder coating completes the part.
|
|
|
|
| |
|
| Diameter |
7.44" |
|
|
| Height |
3.78" |
|
|
| Material |
Aluminum |
|
|
| Thickness |
0.063" |
|
|
| Finish |
Powder Coated |
|
|
|
|
|
|
Outer Heads
These aluminum parts are Outer Heads
for cryogenic containers. These parts
require consistent wall thickness throughout. A smooth surface finish
provides an excellent base for
high gloss metallic paint.
|
|
|
|
| |
|
| Diameter |
18.36" |
7.25" |
|
| Height |
12.45" |
6.98" |
|
| Material |
Aluminum |
Aluminum |
|
| Thickness |
0.125" |
0.125" |
|
| Finish |
Mill |
Mill |
|
|
|
|
|
Bowl
This stainless steel part is used by municipalities to divert storm water
run-off. After forming the part, HMS spot welds a stainless steel handle
to the center area and affixes a rubber gasket around the flange. The
completed assembly is etched to assist the municipalities with identification.
|
|
|
|
| |
|
| Diameter |
23.25" |
|
| Height |
07.13" |
|
| Material |
Stainless |
|
| Thickness |
0.048" |
|
| Finish |
Mill |
|
|
|
|
| |
|
